Juice Lubes Chain Juice Dry Conditions Chain Lube

When applied to the chain, the carrier quickly “searches” its way in between all the pins and rollers of the chain which is where it is needed the most. At this point when the optimum penetration of the chain has been achieved relative to the amount of lube applied at that time, the carrier evaporates, leaving behind the lubricating element which is enclosed in a thin, dry to the touch film which does not allow loose, dry and lightweight contaminants to stick to it. This results in a cleaner and quieter chain.

Directions:
For top performance, apply to a degreased chain and dry chain.

Un-screw nozzle and pierce security seal. Re-attach nozzle and take care to only open the flow valve a very small amount to avoid over application. Then rest the tip of the nozzle on the rollers of the chain and whilst slowly back pedalling the cranks for 2 complete revolutions, gently squeeze the bottle to apply a thin stream of Chain Juice Dry to the chain.

HINT! At this point, if it is dripping on the floor you are applying it too quickly!!

Because of the way in which Chain Juice Dry works it is best to apply the lube in 2 – 4 thin layers leaving a few minutes between each layer for the penetration and evaporation process to take place.